Albanija
Argentina
Australija
Austrija
Belgija
Bosna i Hercegovina
Brazil
Bugarska
Crna Gora
Danska
Estonia
Filipini
Finska
Francuska
Grčka
Hrvatska
Irska
Italija
Južna Afrika
Kanada
Kolumbija
Letonija
Litvanija
Luksemburg
Mađarska
Meksiko
Moldavija
Nemačka
Nizozemska
Norveška
Novi Zeland
Poljska
Portugal
Rumunija
Severna Makedonija
Sjedinjene Američke Države
Slovačka
Slovenija
Srbija
Turska
Ujedinjeno Kraljevstvo
Ukrajina
Češka
Čile
Španija
Švajcarska
Švedska
MusicNomad MN611 Truss Rod Neck Relief Measure and Adjust Kit Alat za održavanje gitare
Brend: MusicNomad
Kod proizvoda: 1313174
Brend: MusicNomad
Kod proizvoda: 1313174
MusicNomad MN611 Truss Rod Neck Relief Measure and Adjust Kit Alat za održavanje gitare
The MusicNomad MN611 Truss Rod Neck Relief Measure and Adjust Kit gives Gibson and USA-built PRS owners everything needed to dial in neck relief at home. The bundle pairs a precision stainless steel feeler gauge with a 5/16-inch carbon steel truss rod wrench and a clever pick-style capo.
- Three common relief measurements (.006", .008", .010") printed on the gauge handle for electric, acoustic, classical, and bass guitars.
- Pick Capo holds the string at the first fret without bulky clamp tension, allowing for accurate and consistent readings.
- 5/16" wrench with magnetic Phillips screwdriver tip removes tiny truss rod cover screws without dropping them
- Ergonomic rubber handle and protective headstock bumper keep the finish safe during adjustments
Measure and Adjust Neck Relief on Gibson and PRS Guitars
The MusicNomad MN611 Truss Rod Neck Relief Measure and Adjust Kit bundles the two tools needed for a proper truss rod setup. A precision stainless steel gauge offers the three most common neck relief measurements (.006", .008", .010") with instructions printed directly on the handle. Included in the set is a pick-style capo that holds the low E, A, and D strings at the first fret without the bulk of a regular capo, giving a clean reading at the sixth fret.
Premium Wrench Built for the Headstock
This 5/16-inch truss rod wrench is built from carbon steel and sized specifically for Gibson and USA-made PRS guitars. A magnetic Phillips screwdriver on the opposite end lifts the tiny truss rod cover screws safely, while the ergonomic rubber handle and protective bumper prevent scratches on the headstock finish.
Dokumenti
Bezbednosna uputstva
Pogledaj uputstvo za upotrebu za detaljna bezbednosna uputstva za ovaj proizvod.
